I am on to my next adventure in the Mickey and the Roadster Racer Birthday Party preparations. Here are some winner circle water bottles I made with a Mickey and the Roadster Racer Twist.
Below are some affiliate links and I may make a commission for purchases made through the following links.
This is a very simple project. I used my Cricut Explore to cut out the Mickey Ears and his number 28, but you can trace and cut the Mickey Ears on the black cardstock. For the number 28, you can print it on the computer or write it on the yellow cardstock and cut a circle around it and glue to the ears (if you don’t have a Cricut). Also you could just use the Mickey Ears only with the duct tape.
Measure the water bottle around to find out how long to cut the duct tape. Also remove the water bottle label.
Put the duct tape around the bottle where the label would have been.
Glue on the number 28 using the EK Tools Zig Memory System 2 Way Squeeze and Roll Glue Pen. This glue pen is my absolute favorite one (I’ve tried quite a few), it dries clear, comes out easy, and a little glue goes a long way.
Using the hot glue gun, glue on the Mickey Ears onto the water bottles
Your Mickey and the Roadster Racers Water Bottles are all done and winner circle ready.
Stay tuned for more Mickey and the Roadster Racer Birthday Ideas and Crafts. If you are interested in a Mickey and the Roadster Racer birthday banner, here is my blog post on how to create one http://www.cookiescoffeeandcrafts.com/mickey-and-the-roadster-racers-birthday-ideas/.